CABINETRY ASSEMBLY FOR CRT CONSOLE SYSTEMS
3. Pass the driver through the access in the bottom of the support rail and drive #10x3/4" flakeboard screws* up into the Formica writing surface. Refer to Figure
4. Align as necessary using an electric screwdriver with a #2 Phillips driver.
NOTE: Hex extensions or long hex drivers will not pass through the holes.
C A U T I O N
Use only
Figure 3-8 JOINING FORMICA
Figure
3.8ATTACHING THE FORMICA WRITING SUR- FACE
1.Position all writing surfaces on the writing support rails.
2.Where a split occurs in the Formica writing surface, insert wood biscuits into the slots on the sides of the surfaces. Refer to Figure
HINT: To help align the Formica writing surfaces flush, it is advisable to glue the biscuits into place
using white carpenter’s glue. | Figure |
| ING SURFACE |
| February 1996 |
Part No. |