EFJohnson VR-CM50 manual 14UNIVERSAL PENCIL DRAWER MOUNTING, 15TYPEWRITER EXTENSION AS

CABINETRY ASSEMBLY FOR CRT CONSOLE SYSTEMS

3.10.4UNIVERSAL PENCIL DRAWER MOUNT- ING (OPTION 4)

1.Remove the pencil drawer from the mounting frame by depressing the black slide retainers. Refer to Fig- ure 3-14.

2.Position the mounting frame in the desired location between the writing support rails - 1 " back from the front of the Formica writing surface.

3.Drive six (6) #10 x 3/4 flakeboard screws up into wood. Refer to Figure 3-14

4.Re-insert the pencil drawer.

3.Attach the typewriter extension support to the type- writer extension using four (4) 10x3/4 flakeboard screws. (On 21" typewriter extensions, five (5) 10x3/4 flakeboard screws are used).

4.Attach the entire assembly to the position desired on the Formica writing surface. Use four (4) 10x3/4 flakeboard screws to secure the assembly to the For- mica writing surface. (On 21" typewriter exten- sions, five (5) 10x3/4 flakeboard screws are used).

5.Hand turn the leveling feet at the bottom of the mod- esty panel to ensure a level typewriter extension surface.

Figure 3-14 UNIVERSAL PENCIL DRAWER

MOUNTING

Figure 3-15 TYPEWRITER EXTENSION AS-

3.10.5 TYPEWRITER EXTENSION ASSEMBLYSEMBLY (OPTION 5)

Refer to Figure 3-15.The Typewriter Extension Assembly consists of a typewriter extension, a type- writer extension support, two (2) triangle braces and hardware. It is packed flat for shipping and must be assembled in the field.

NOTE: The following assembly instructions pertain to both 18" and 21" typewriter extension lengths.

1.Attach the triangle brace to the modesty panel using three (3) 10-32x1/2 pan head screws for each trian- gle brace.

2.Flip the typewriter extension over on its top side to attach the other side of the triangle brace. Use three

(3) 10x3/4 flakeboard screws for each triangle brace and attach to the typewriter extension.

3.10.6PIE SUPPORT RAIL MOUNTING (OP- TION 6)

Refer to Figure 3-16.The Pie Support Rail is attached using the same hole pattern as the writing support rail.

1.Mount the rail with the angle of the rail following the angle of the break in the writing surface.

2.When the Formica writing surface is attached, use two (2) flakeboard screws on each side of the writ- ing surface break. Refer to the Section 3.5.

February 1996
Part No. 004-3039-274	3-8