EFJohnson VR-CM50 manual 16PIE SUPPORT RAIL MOUNTING, 3.10.7CRT MONITOR SHELF - FXM-192OP- TION

CABINETRY ASSEMBLY FOR CRT CONSOLE SYSTEMS

2. Mount the CRT Monitor Shelf

The monitor shelf is mounted in the base section of the FC192 cabinet. Refer to Figure 3-18.

a. Snap Tinnerman clips to the 6th hole counting down from the top of the lower frame side on both the front left and right sides of the cabinet.

b. Snap Tinnerman clips to the 8th hole counting down from the top of the lower frame side on both the rear left and right sides of the cabinet.

c. Install the monitor shelf with the four (4) 12-24x pan head Phillips screws provided. The monitor shelf mounts with the 2.5" hole to the rear.

Figure 3-16 PIE SUPPORT RAIL MOUNTING

d. Remount the distribution rail to holes 31 and 33 (counting up from the console bottom) using the

(4) -20x3/4 hex bolts previously removed.

3.10.7CRT MONITOR SHELF - FXM-192 (OP- TION 7)

The hardware in Table 3-1is included with the

Monitor Shelf assembly (FXM-192):

1.Mount the Tinnerman Clips

a. Snap the Tinnerman clips onto the left and right

sides of the console frame at the second, third and seventh hole, counting up from the bottom cowl. Repeat the same, counting down from the top cowl.

b. Attach the EIA Shims - Attach the EIA shims using

two (2) 12-24x pan head Phillips screws per shim to the Tinnerman clips at holes 3 and 7, 12 and 16, counting down from the top cowl.

c.Remove the Distribution Rail - Remove the distribution rail at the rear of the cabinet by removing the four (4) 1/4-20x3/4 hex bolts. Put them aside to use for reassembly.

d.Install the Right and Left Inner Closures - Install the right-side inner closure by sliding it in from the front of the console and placing its shim between the already installed "EIA" shims" and "inner closure" itself. (All holes line up when seated properly). Screw in the right-side closure with the four (4) 12-24x1" black truss head Phillips screws and #12 black nylon washers. Repeat this procedure for the left side.

Figure 3-17 INSTALLING TINNERMAN CLIPS

	February 1996
3-9	Part No. 004-3039-274