SECTION 5 CRT-BASED ELECTRONICS ASSEMBLY PART II
5.1 INTRODUCTION
If you have ordered a
II, details the additional assembly required for either a complete E.F. Johnson
5.2 INSTALL THE PC AND UPS
Table 5-1 PC UPS OPTIONS
PC CPU Part No. | 200TC4862501 |
|
|
Possible option numbers for the PC UPS | |
|
|
Part Number | Country |
|
|
North America | |
Great Britain, S. Africa | |
Europe | |
India | |
New Zealand/Australia | |
|
|
7.Place the PC UPS
5.3CONNECT THE PC CPU AND PC UPS POW- ER CORDS
Part Numbers:
PC UPS -
PC CPU - 200TC4862501
Refer to Figure
1.Connect one end of the supplied power cord to the PC CPU. Plug the other end into the top left recep- tacle at the rear of the PC UPS. (Coil up the excess cable and secure).
2.Connect one end of the other supplied power cord to the PC UPS. Plug the other end into the customer- furnished receptacle box feeding the console.
(Leave enough slack on the power cord so that it will not unplug when the tray is fully extended).
5.Remove the two bottom screws of the PC CPU (holding the PC cover together) and completely slide the PC CPU into the PC tray bracket.
6.Replace the two screws that were removed with two
(2)
Figure 5-1 CPU AND UPS POWER CONNEC-
TIONS
| February 1996 |
Part No. |