Eiki EIP-1000T Turning the Projector On/Off, Connecting the Power Cord, Turning the Projector on

Turning the Projector On/Off

Connecting the Power Cord

Supplied	Power cord
accessory

Plug the supplied power cord into the AC socket on the rear of the projector.

AC socket

Turning the Projector on

Note that the connections to external equip- ment and power outlet should be done be- fore performing the operations written be- low. (See pages 23 to 28.)

Remove the lens cap and press oSTANDBY-ON on the projector or fON on the remote control.

Note

•About the Lamp Indicator

The lamp indicator illuminates to indicate the status of the lamp.

Red: The lamp is on.

Blinking in red: The lamp is warming up or shutting down.

Green: The lamp is shut down abnor- mally or the lamp should be re- placed.

•When switching on the projector, a slight flick- ering of the image may be experienced within the first minute after the lamp has been illumi- nated. This is normal operation as the lamp’s control circuitry is stabilising the lamp output characteristics. It should not be regarded as faulty operation.

•If the projector is put into standby mode and immediately turned on again, the lamp may take some time to start projection.

Info

•English is the factory default language. If you want to change the on-screen display to another language, change the language according to the procedure on page 43.

Lamp indicator

Power indicator

STANDBY-ON button

ON button

28