Eiki EIP-10V owner manual Maintenance, Replacing the Lamp

APPENDICES

4-2 MAINTENANCE

4-2-1 REPLACING THE LAMP

When the lamp's total working time accumulates to over 1850 hours, the on-screen display (OSD) will deliver a message recommending that you replace the lamp. Please contact a service center to replace the lamp as soon as possible, or refer to the following instructions to replace it yourself.

TO REPLACE THE LAMP

1.Turn off the projector by pressing the "Power" button

2.Allow the projector to cool down for at least one hour.

3.Switch off the power and disconnect the power cord.

4.Loosen the screw on the lamp cover and remove the lamp cover. (Drawing 62)

5.Loosen two screws on the lamp module (Drawing 63) remove the lamp module by pulling on the handle (Drawing 64)

6.Insert a new lamp module (Drawing 65) into the socket: make sure it is in position.

7.Reverse steps 4 and 5

8.Ensure that the lamp cover is securely attached and flush with the bottom of the unit. The unit will not operate with the cover incorrectly installed.

9.Reset the lamp timer

DRAWING 62 DRAWING 63

DRAWING 64 DRAWING65

뿄 뫖