APPENDICES
To reset the lamp timer
1.Press the Menu button on control panel or remote controller.
2. Go into the system menu and move the cursor to the lamp reset item.
3.Select "Yes" to execute the lamp reset and the lamp hours will reset to 0 hour.
DRAWING 66
Important
*Do not touch the lamp immediately after it has been used: it will be extremely hot. Allow the fan to finish its cooling process, then turn the projector off, and disconnect the power cord. Then allow at least one hour for the lamp to cool down before handling.
*Do not remove any screws other than the lamp cover screw and the lamp housing screws. Removing other screws could result in electric shock.
*Although the mercury content of the lamp is minuscule, spent lamps should be treated as hazardous waste. Consult federal, state/provincial or local regulations for proper disposal.
CAUTION
Continuing to use the lamp after the replace the lamp message has been displayed on the screen may result in the lamp exploding. If this occurs, pieces of glass may scatter inside the projector, and out into the room. If this occurs, do not touch them, as the pieces of glass may cause injury. The bulb contains a small amount of mercury: ventilate the area well. Contact your dealer for servicing: do not attempt to service the projector yourself.
뿄 밐
