Eiki EIP-1600T owner manual Controlling the Projector by a Computer, Info

Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS- 232C adaptor and an RS-232C serial control cable (cross type, commercially available), the com- puter can be used to control the projector and check the status of the projector. See page 58 for detail.

When connecting to a computer using an RS-232C serial control cable and a DIN- D-sub RS-232C adaptor

Supplied accessory

Computer

DIN-D-sub	To RS-232C terminal
RS-232C
adaptor

To RS-232C terminal

DIN-D-sub RS-232C adaptor

RS-232C serial control cable (cross type, commercially available)

Note

•The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details.

•See page 58 for connection of an RS-232C serial control cable.

Info

•Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may damage your computer or projector.

•Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your computer.

27

EIP-1600T_EN_g 27 06.1.24, 1:04 PM