Eiki EIP-1600T 1Adjusting the Computer Image, 2Special Modes Setting, 4Checking the Input Signal

Computer Image Adjustment (“Fine Sync” menu)

Fine Sync		INPUT 5
Clock	0
Phase	0
H-Pos	0
V-Pos	0

Reset
Special Modes	1080I
Auto Sync	On

Cur. sig. freq : H 33.8 kHz / V 60 Hz

1Adjusting the

Computer Image

Use the Fine Sync function in case of irregulari- ties such as vertical stripes or flickering in por- tions of the screen.

Selectable items	Description
Clock	Adjusts vertical noise.
Phase	Adjusts horizontal noise (similar
	to tracking on your VCR).
H-Pos	Centers the on-screen image by
	moving it to the left or right.
V-Pos	Centers the on-screen image by
	moving it up or down.

Note

•You can automatically adjust the computer image by setting “Auto Sync” in the “Fine Sync” menu to “On” or pressing f AUTO SYNC on the remote control.

•“Clock”, “Phase”, “H-Pos” and “V-Pos” can- not be adjusted when INPUT 6 is selected.

•The adjustable area of each item may be changed according to the input signal.

•To reset all adjustment items, select “Reset” and press i ENTER.

Menu operation n Page 41

2Special Modes Setting

Ordinarily, the type of input signal is detected and the correct resolution mode is automatically selected. However, for some signals, the opti- mal resolution mode in “Special Modes” in the “Fine Sync” menu may need to be selected to match the computer display mode.

Note

•Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see.)

•Information on the currently selected input sig- nal can be confirmed in item 4.

3Auto Sync (Auto Sync Adjustment)

Selectable items	Description
On	Auto Sync adjustment will
	occur when the projector is
	turned on or when the input
	signals are switched, when
	connected to a computer.
Off	Auto Sync adjustment is not
	automatically performed.

Note

•Auto Sync adjustment is also performed by pressing f AUTO SYNC on the remote con- trol.

•The Auto Sync adjustment may take some time to complete, depending on the image of the computer connected to the projector.

•When the optimum image cannot be achieved with Auto Sync adjustment, use manual ad- justments.

4Checking the Input

Signal

This function allows you to check the current in- put signal information.

46

EIP-1600T_EN_j 46 06.1.24, 1:07 PM