
BASIC OPERATION
TURNING ON / OFF PROJECTOR
TURNING ON PROJECTOR
1Complete peripheral connections (with Computer, VCR, etc.) before turning on projector. (Refer to "CONNECTING TO PROJECTOR" on Pages 12~15 for connecting that equipment.)
2Connect a projector's AC Power Cord into a wall outlet and turn MAIN ON / OFF SWITCH to ON. LAMP indicator lights RED, and READY indicator lights GREEN.
3Press POWER
Current Input position and Lamp status are also displayed on screen for 5 seconds. (Refer to "LAMP MANAGEMENT" on page 45.)
LAMP STATUS
INPUT 1
12
30
Preparation Display disappears after 30 seconds.
TURNING OFF PROJECTOR
1
2
3
Press POWER
Press POWER
Cooling fans will operate for approximate 2 minutes after projec- tor is turned off. To power down completely, turn MAIN ON/OFF SWITCH to OFF and disconnect AC Power Cord.
TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.
Power off?
Message disappears after 4 seconds.
When Power Management function mode is Ready or Shut down, projector detects signal interruption and turns off Projection Lamp automatically. Refer to “Power Management” on pages 39 and 40.
When WARNING TEMP. indicator flashes red, projector is automatically turned off. Wait at least 5 minutes before turning on projector again.
When both WARNING TEMP. and READY indicators to flash, follow procedures below:
1.Turn MAIN ON / OFF SWITCH to OFF.
2.Turn a projector on again.
When WARNING TEMP. indicator continues to flash, follow procedures below:
1.Turn MAIN ON / OFF SWITCH to OFF and disconnect AC Power Cord from an AC outlet.
2.Check Air Filters for dust accumulation.
3.Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 44.)
4.Turn a projector on again.
If WARNING TEMP. indicator should still continue to flash, contact sales dealer where you purchased this projector or service center.
21