Eiki LC-W4 instruction manual Fig-8

6This projector has three Light-Block Sheets. Use the Light-Block Sheet corresponding with the lens. (Refer to the list below.)

Set the Light-Block Sheet through the lens.

Make sure the shape of the Light-Block Sheets are correct and be sure to set them as shown in the Fig. 8.

NOTE:

●Be sure to set each Light-Block Sheet as shown in Fig. 8.

●Make sure the mark (TOP and BACK) on the Light-Block Sheets are correct and set them properly.

Light-Block Sheets for each lens.

Lens Model No.		Type No. (Part No.)
LNS-S02, LNS-S02Z, LNS-W04	TYPE	FD1 (610 322 8051)
LNS-M01, LNS-T02, LNS-W02,
LNS-M01Z, LNS-W02Z, LNS-S01,	TYPE	FE1 (610 322 7269)
LNS-W03, LNS-W07
LNS-W01, LNS-T01, LNS-W01Z,	TYPE	FF1 (610 322 7788)
LNS-T01Z, LNS-S03,	Not include Light-Block Sheet
LNS-W06, LNS-W05	Mounting Base and screws.

For Models

LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z

LIGHT BLOCK SHEET

Make sure the sheet figure is correct and put in proper position.

LIGHT BLOCK SHEET

Make sure the sheet figure is correct and put in proper position.

E

Mount the Light-Block Sheet with two (2) screws.

Fig-8

- 4 -