Eiki LC-W4 instruction manual Fig-4

4Replace the Lens Cap on the rear (mounting side) of the Projection Lens and mount a lens on the Lens Attachment with four (4) Screws. (Use the screws attached on the lens.)

Connect the Lens Motor Lead connector to the socket on the right-top of the Lens Attachment (Motor Driven Lens only). See Fig. 5.

When installing the LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z, be sure to mount the lens and the Light-Block Sheet Mounting Base on the Lens Mounting Bracket. (See Fig. 8)

LENS LOCK SCREW	LENS ATTACHMENT	LENS LOCK
		LEVER

DRIVER

IN THE LENS Part No. (610 275 6029)

Fig-4

LIGHT-BLOCK SHEET

MOUNTING BASE

Part No. (610 303 9596)

Kit parts with two (2) screws.

Lens attachments For each lens.

LOCATE MOTOR

LENSON RIGHT SIDE ATTACHMENT

SOCKET

CONNECTOR

LENS MOTOR LEAD Fig-5

Lens Model No.		LENS ATTACHMENT
		TYPE No. (PART No.)
LNS-W01, LNS-W01Z, LNS-W02Z,		Lens Attachment 01
LNS-W03, LNS-T01, LNS-T01Z,		POA-LNA-01
LNS-T02, LNS-S02, LNS-S02Z,
	(610 303 8742)
LNS-S03, LNS-M01Z, LNS-W04,
LNS-W05, LNS-W06, LNS-W07
LNS-W02, LNS-M01, LNS-S01		Lens Attachment 02
		POA-LNA-02
		(610 304 6228)

5	Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 6.)	E
	Install the lens into the projector. Grasp the Lens Lock Lever and turn the Lever fully downward

until lever is Locked (clicked position) properly. (See Fig. 7.)

When installing the Motor Driven Lens, be sure to mount the Lens Motor on the right side. (See Fig. 5.) After installing the lens, make sure the lens is not loose and properly installed.

LENS LOCK RELEASE LENS LOCK

Grasp (unlock) the Lens Lock Lever and pull upward.

Grasp (unlock) the Lens Lock Lever and fully pull downward until it is locked (clicked).

Fig-6

Fig-7

- 3 -