Eiki LC-XB200 Large , Middle or Small , Arrow , Finger or Dot and press, Remote control

Setting

Pointer	Pointer
You can emphasize a part of the projected image with this
function. Use the Point ed buttons to choose Spotlight
(Large, Middle or Small) , Arrow, Finger or Dot and press
the SELECT button. See "Pointer Function" on page 13.

Remote control

The eight different remote control codes (Code 1–Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should set on both the projector and the remote control. For example, operating the projector in Code 7, the remote control code also must be switched to Code 7.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control:

While holding down the MENU button, press the IMAGE button the number of times corresponding to the remote control code for the projector. See “Remote Control Code” on page 12.

✔Note:

Arrow

Remote control

•When different codes are set on the projector and on the remote control, any operation cannot be made. In that case, switch the code on the remote control to fit the code on the projector.

•If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.

55