Eiki LC-XB200 owner manual Lamp control, Lamp life control

Setting

Standby mode

This function is available when operating the projector via network.

Normal....... Supply the power to the network function even

after turning off the projector. You can turn on/ off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off.

Eco............. Select Eco when you do not use the projector

via network. The projector’s network function will stop when turning off the projector.

Refer to the owner’s manual “Network Set-up and

Operation”.

✔Note:

• Factory default is Eco.
• When selecting Normal, the cooling fans may be running			Lamp life control
depending on the temperature inside the projector even if
the projector is turned off.
Lamp control
	Lamp control
	This function allows you to change brightness of the
	screen.
		Normal....... Normal brightness
		Eco............ Lower brightness reduces the lamp
		power consumption and extends the
		lamp life.

Lamp life control

Select the lamp operation when the total lighting time of a lamp exceeds the recommended total hours of use.

Mode 1	The lamp can be turned on even after
	exceeding the recommended total
Mode 2	hours of use.
	The lamp can be turned on even after
	exceeding the recommended total
	hours of use. But the projector turns off
	automatically after 3 minutes.

✔Note:

•Lamp mode cannot be changed for a while after turning on the projector. Lamp needs some time to stabilize after the power is turned on. Stored lamp mode will be active after the lamp is stabilized.

•If Mode 2 has been selected and the projection lamp exceedes the recommended total hours of use, the replacement icon will be displayed at the time of power- on. Then the projector will turn off after 3 minutes.

Lamp replacement icon

•The Lamp replacement icon will not appear when the Display function is set to Off (p.48), during Freeze (p.27), or No show (p.28).

54