Setting
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back of the projector is switchable for computer input or monitor output. (See page 9) Select Computer 2 or Monitor Out with the Point ▲▼ buttons.
Computer 2 . . computer input
Monitor Out . monitor out
Terminal function is not available when selecting Computer 2 to the input source. Change the input source to the others (Computer 1, and so on) so that the Terminal function will be available. (pp.25, 36, 37)
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready | When the lamp has been fully |
| cooled down, the POWER |
| indicator changes to green |
| blinking. In this condition, the |
| projection lamp will be turned on |
| if the input signal is reconnected |
| or any button on the top control or |
Shut down | remote control is pressed. |
When the lamp has been fully | |
| cooled down, the power will be |
Off | turned off. |
Power management function is | |
Timer | off. |
If the input signal is interrupted | |
| and no button is pressed for more |
| than 30 seconds, the timer display |
| with No signal appears. It starts |
| the countdown until the lamp is |
| turned off. Use the Point ▲▼ |
| buttons to set the Timer (1~30 |
| min). |
Note:
Factory default is Ready: 5 min.
Direct on
When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.
Note:
•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 20). If the projector is turned off in the incorrect sequence, the Direct on function will not work properly.
Power management
Time left before Lamp is off.
49
