Appendix
No image | – Check the connection between your computer or video |
| equipment and the projector. See pages |
| – See if the input signal is correctly output from your computer. |
| Some laptop computers may need to change the setting for |
| monitor output when connecting to a projector. See your |
| computer’s instruction manual for the setting. |
| – It takes about 30 seconds to display an image after turning on |
| the projector. See page 18. |
| – Check the Input signal, color system, video system or computer |
| system mode. |
| – Make sure the temperature is not out of the specified Operating |
| Temperature |
| – When No Show is operating, the image cannot be displayed. |
| Press the NO SHOW button or any other button on the |
| remote control. |
No sound | – Check the audio cable connection from audio input source. |
| – Adjust the audio source. |
| – Press the Volume + button. See page 24. |
| – Press the Mute button. See page 24. |
| – When the AUDIO OUT is |
| speaker is not available. |
| – Is the image projected? You will hear the Computer and Video |
| sound only when the image is projected. |
The color is strange. – Check the Input signal, color system,video system or computer system mode.
–Make sure the Blackboard is not selected on Image select menu. See pages 32, 39.
Some displays are not seen during the operation.
– Check the Display function. See page 46.
Auto PC adjustment function – Check the Input signal. Auto PC adjustment function can not
does not work..work when 480p,575p.720p,480i,575i,1035i or 1080i is selected. See page 29.
The setting does not remain after turning off power.
–Make sure you selected Store after adjusting setting. Some settings can not be stored if not registered with Store. See pages 33, 41.
Power management does not – Power management function can not work while Freeze or No
work. | Show function is running. See page 49. | |
|
| |
Capture function does | – Check the connection and the input signal to see if there is | |
not work.. | signal. | |
|
| |
Auto setup does not | – Make sure Off is not selected at any function of Auto setup. | |
work properly. | See page 45. | |
| – Make sure On is not selected at the Ceiling function. | |
| See pages 35, 43. | |
|
| |
Auto keystone function does not – | Make sure the Auto keystone function is not set to Manual. | |
work even when the projector is | Press the AUTO SETUP button on the top control. See | |
tipped.. |
| pages 23, 45. |
64
