Setting
Lamp control
This function allows you to change brightness of the screen.
High | Brighter than the Normal mode. |
Normal | Normal brightness |
Eco | Lower brightness reduces the lamp |
| power consumption and extends the |
| lamp life. |
Note:
•Lamp mode can not be changed for a while after turning on the projector. Lamp needs some time to stabilize after the power is turned on. Stored lamp mode will be active after the lamp is stabilized.
Remote control
This projector provides two different remote control | Remote control |
codes: the |
|
secondary code (Code 2). This switching function |
|
prevents remote control interference when operating |
|
several projectors or video equipment at the same time. |
|
When operating the projector in Code 2, both the |
|
projector and the remote control must be switched to |
|
Code 2. |
|
To change the code for the projector: |
|
Select either Code 1 or Code 2 in this Setting Menu. |
|
To change the code for the remote control: |
|
Press and hold both the MENU and IMAGE buttons |
|
together for 5 seconds or more. After changing the code, |
|
make sure the remote control operates properly. |
|
Note:
•When different codes are set on the projector and on the remote control, any operation cannot be made. In that case, switch the code on the remote control to fit the code on the projector.
•If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.
52
