LC-XC1
Ceiling
When this function is “On,” the top / bottom and the left / right reversed picture is provided to project the image from a ceiling mounted projector.
Rear
When this function is “On,” the left / right reversed picture is provided to project the image to a rear projection screen.
Split wipe
Turn this function “On” in the SETTING MENU. The picture will change into next one by sliding black image side ways like drawing the black curtains when the input source is turned into another one.
Remote control
This projector has two different remote transmit codes; the factory- set normal code (Mode 1) and the secondary code (Mode 2). This switching function prevents the remote control operation mixture (jam) when operating several projectors or video equipment
together. When operating the projector in “Mode 2,” both projector and Remote Control must be switched to
“Mode 2.”
To change the code of the projector
Set the Remote control in SETTING MENU to “Mode 2.”
To change the code of the Remote Control
Press both the MENU and the NORMAL buttons on the Remote
Control together for over 10 seconds.
After changing the code, make sure the Remote Control operates properly.
To return to the normal code (Mode 1), operate both projector and
Remote Control in the ways above again.
NOTE : When the
transmit code automatically
returns to the normal code (Mode 1).
Lamp age
The Lamp age function is designed to reset the lamp replacement monitor timer. When replacing the lamp, reset the lamp replacement monitor timer by using this function. (Refer to page 40.)
The language used in the
1
2
Press the MENU button and the
appear. Press POINT LEFT/RIGHT buttons to select LANGUAGE and press the SELECT button. Another dialog box LANGUAGE MENU will appear.
Press the POINT DOWN button and a
appear. Move the arrow to the language that you want to set, and then press the SELECT button.
37
