30 Chapter3SettingMonitor
3-7. Setting Signal Bandwidth
The range of frequency and detection sensitiv ity of the change in signal can be switched.
Attention
• The g raphics board supporti ng signal display is required. Refer to t he User’s Manual of the graphics board.
• Th is function cannot be used w ith HDMI input.
Procedure
1. Pre ss to turn off t he monitor.
2. Holding down, press for at least two seconds to turn on the mon itor.
The “Optional Settings” me nu appears.
3. Choose “ Signal Selection” from “Optional Settings”, and press .
4. Choose t he input signal to set with or , and press .
5. Select “Nor mal” or “Wide” with or , and press .
6. Pre ss twice.
7. Select “Finish” wit h or .
8. Pre ss .
3-8. Switching USB Port Automatically
This function allows the input signal to l ink the USB upstream port when one monitor is con nected to two PCs.
This can switch the USB port automatically acc ording to the switch of the input signal. To calibrate one monitor
using two PCs, the USB cables do not need to be connected again. USB device s such as the mouse and keyboard
connected to one monitor can be used wit h two PCs.
Attention
• To switch the USB port t o be used, two USB cables are required. P repare cables.
• If a st orage device such as a USB memory is connect ed to the monitor, remove the device before changing t he setting.
Otherwise, data may be lo st or damaged.
• The key a rrangement of the keyboard can not be changed.
Note
• W hen the “Input Selection” function is se t to “Auto”, the USB port automatically switches according to the sw itch of the
input signal.
• The USB dow nstream port can be oper ated using the currently mon itored PC.
Procedure
1. Choose “ Tools” from the Adjustment menu, and press .
2. Choose “ USB Selection” from “Tools”, and press .
3. Choose t he input signal to set with or , and press .
4. Select “USB-1” or “USB-2” with or .
5. Pre ss to exit.