Priority setting

Performance

 

 

 

 

 

D-Sub

If signals from both inputs are present, the monitor

 

 

 

gives preference to D-Sub for the cases shown below:

 

 

 

• When the power of the monitor is turned ON (see

 

 

 

note 1).

 

 

 

• When the signal input to D-Sub is changed even if

 

 

 

active input was BNC.

 

BNC

If signals from both inputs are present, the monitor

 

 

 

gives preference to BNC for the cases shown below:

 

 

 

• When the power of the monitor is turned ON (see

 

 

 

note 1).

 

 

 

• When the signal input to BNC is changed even if

 

 

 

active input was D-Sub.

 

Manual

The monitor will not detect signals automatically in

 

 

 

this mode. Select the active input by pressing the

 

 

 

input signal selection button on the monitor’s front

 

 

 

panel (see note 2).

 

 

 

 

 

 

 

 

 

 

 

 

1The Input Priority function does not automatically reactivate when the monitor has been in the power saving mode.

2The Input selection button on the front panel can be used to select either D-Sub or BNC as the active input at any time.

Beep

Use this feature to set the beeper ON or OFF. If the beeper is ON, the monitor will generate beep signals as shown below. If the beeper is OFF, the monitor will not beep.

Short beep

ScreenManager item selected.

 

• ScreenManager parameter adjusted to minimum

 

 

or maximum limit.

 

BNC/D-Sub selection button pressed.

Long beep

AUTO-SIZING button pressed.

 

• ScreenManager data-save executed.

 

 

 

Four short beeps

Monitor not connected correctly.

 

PC turned off.

 

• Monitor received unsupported signal frequency.

Two short beeps

Monitor is in the advance notice mode of the Off

every

 

Timer. The monitor will be in the Off Timer

fifteen seconds.

 

Mode within 15 minutes.

 

 

 

36 2 ADJUSTMENTS & SETTINGS USING THE SCREENMANAGER

Page 36
Image 36
Eizo T960 user manual Beep, Performance