4 TROUBLESHOOTING

4-1 Troubleshooting

This page presents problems that can be corrected by the user. If a problem persists even after applying the suggested remedies, contact an EIZO dealer.

nProblems caused by incorrectly setting of the termination switch

 

Problems

Points to check with possible solutions

1)

Misconvergence of colors.

The termination switch on the rear of the monitor

2)

Focus is dull.

should be set to 75 Ω position (default) for

connection to a single monitor.

3)

PowerManager does not

If it is set to the ∞ position when using a single

 

work properly in VESA

 

monitor, some problems like 1) ~ 4) may occur.

 

setting.

 

Check that the switch position is set to 75 Ω

4)

Slight shadow appears on the

position.

 

edges of the screen image or

 

 

 

text. (Only for the BNC

 

 

connections.)

 

n No picture

Problems

Points to check with possible solutions

1) Indicator status: OFF

Check that the power cord is correctly connected.

2) Indicator status: GREEN

Try pressing a key on the keyboard, or clicking the

mouse. (The monitor may be in a power saving

 

 

mode)

 

Check brightness and contrast settings. Minimum

 

settings will cause screen to be blank.

3) Indicator status: GREEN

Try pressing any keys on the front panel. (The

(flashing)

monitor may be in “Advance Notice Mode”).

4) Indicator status: YELLOW

Try pressing a key on the keyboard, or clicking the

 

mouse. (The monitor may be in a power saving

 

mode.)

5) Indicator status: YELLOW

Try pressing any keys on the front panel or switch

(flashing)

the monitor off and then on. (The monitor may

 

be in “Off Timer Mode”.)

 

If the problem persists, switch off the monitor power

 

for a few minutes, then switch it back on and try

 

again.

 

 

6) No signal detectederror

Check that the PC is switched ON.

message appears.

Check that the signal cable is properly connected

 

to the graphics board or PC.

 

Check that the graphics board is correctly inserted

 

in the PC.

 

Switch the signal input by pushing the BNC/ D-

 

Sub selection button on the front control panel.

 

 

44 4 TROUBLESHOOTING

Page 44
Image 44
Eizo T960 user manual Troubleshooting, No picture