Eizo T960 user manual Imaging problems

		Problems	Points to check with possible solutions
7) “ Out of range” error			Use the graphics board’ s utility software to change
	message appears.		the frequency setting. (Refer to the manual of the
	(Example)		graphics board.)

E

•Whenever an error signal message appears, the signal frequency will be displayed in red.

•Error messages will remain on the screen for 30 seconds, and then disappear. An error message may not appear at all if the signal frequency is extremely high or extremely low.

n Imaging problems

Problems	Points to check with possible solutions
1) The screen is partially dark.	The CRT is not warmed up. Allow 30 minutes for
	the monitor to stabilize.
	Degauss the screen. (Use the degaussing feature in
	the ScreenManager’s “Others” menu. See page
	35.)
	This problem may be caused by the earth's
	magnetism. Adjust the uniformity in the
	ScreenManager's “Screen” menu. See page 22.
2) The entire screen is dark.	Adjust the contrast and brightness using the
	ScreenManager’s “Screen” menu. See page 20.
	Some signal timings can be the cause of this
	problem. To correct this, turn off the monitor,
	then hold down the AUTO-SIZING button and
	“down” arrow key while turning on the monitor
	again. This will change the signal timing and
	brighten the screen. If the above operation is
	repeated, the screen becomes dark again.

4 TROUBLESHOOTING 45