Design Spot 250 Pro™
©Elation Professional® 11 Design Spot 250 Pro™
5. LAMP INSTALLATION INSTRUCTIONS Installing or replacing the lamp
For a proper and safe lamp change, please read this chapter carefully and follow all
instructions.
Safety Regulations
• Disconnect the unit’s main power supply.
• Allow the unit to cool for at least 15 minutes before attempting any type of service.
• Before you put the Design Spot 250 Pro™ into operation be sure all covers have
been replaced, otherwise you risk damage to the retina and expose to UV radiation!
• When replacing an old lamp always be sure to replace with an approved
replacement. Be sure the replacement lamp meets or exceeds the original lamp
specifications, failure to do so may damage the fixture and void the manufactures
warranty. Be sure to follow all of the lamp handling procedures included with the
new lamp. Never handle the new lamp with your bare hands as the oils from your
skin may damage the lamp and cause premature lamp failure.
Installation Procedure:
1. Set the fixture on its’ back and remove the three Phillips screws labeled “A” and “B”
found on the back plate of the head assembly.
2. Gently pull out the lamp/socket assembly to access the lamp.
3. Gently remove the old lamp by grasping it by the ceramic base.
4. Carefully insert the new lamp into the socket (Only use a MSD 250/2 GY9.5 lamp or