Design Spot 250 Pro™
©Elation Professional® 31 Design Spot 250 Pro™
8.5.3 Reset Colors: This function will only reset the color wheel to the home position.
8.5.4 Reset Gobos: This function will only reset the gobo wheels to the home position.
8.5.5 Reset Shutter: This function will only reset the blackout shutter to the home
position.
8.5.6 Reset Others: This function will reset all other motors not associated with any in
the previously listed reset commands to the home position.
8.6 Effect Adjust:
8.6.1 Test Channel – This menu function allows the user to select each individual
fixture channel and test it’s function independently from the control board.
8.6.2 Lamp adjustment (manual control) – This function readies the fixture for lamp
optimization in a simple single step procedure. This function will center the pan
and tilt motors and at the same time open the shutter and bring the dimmer to
100%. The pan and tilt function will still operate if the fixture needs to be
positioned to a flat clear surface. For more information on lamp optimization
please see Section 5/Page 12.
8.6.3 Calibrate values – This function should only be performed by a technician
qualified to do so. This function allows a user to make small adjustments to the
effect wheels (color, gobo, shutter, etc) to compensate for ware or in the event a
sensor has been knocked slightly out of place. Because improper use of this
function can result in undesired operation this function has been password
protected. The password is 050 and must be entered each time the calibration
menu function is entered. Because calibration is an extremely delicate procedure
instruction on performing this action are left out of this manual. For a first time
calibrator, please contact our customer support team for step by step instructions.
8.7 User Mode Set:
8.7.1 User mode – This function allows the user to create a user defined channel
orders. This will allow the fixture to match the channel order of other fixtures on