12
7.2 Assign Joystick to Pan & Tilt (Cont.)
(3) Press the "Record" button to enter the assign channel option. The LCD will display
the following:
CHANNEL01>OUT01
OK ESC SEL ADJ
(4) Press the "UP" button sixteen (16) times or until your LCD display reads "PAN
>NONE" on the top line as displayed below.
PAN >NONE
OK ESC SEL ADJ
(5) Next, press the "DOWN" button until the LCD display's the Pan channel # for your
fixture. You will have to refer to the DMX chart that came with your light to input this
information. For example, if the Pan channel of your light is channel # 1, then you
would set your controller up as displayed below.
PAN >CH01
OK ESC SEL ADJ
(6) Press the "UP" button one (1) time so that your LCD display’s "TILT >NONE" on the
top line as displayed below.
TILT >NONE
OK ESC SEL ADJ
(7) Next, press the "DOWN" button until the LCD display's the tilt channel # for your
fixture. Once again, please refer to the DMX chart that came with your light for this
information. For example, if the Tilt channel of your light is channel # 2, then you
would set your controller up as displayed below.
TILT >CH02
OK ESC SEL ADJ