17
7.3.2 Record a Moving Light Show (Cont.) (4) Next, set your desired hold and fade time for your first Show step by using the
“SPEED” fader for your HOLD time and the “FADE” fader for your FADE time. The
hold and fade time range is five tenths of a second to ten minutes. Therefore, the
maximum times that can be set to hold or fade a selected scene step is 10 minutes
and the minimum time is .5 second. Note: When adjusting the speed fader, “S”
represents “Speed” followed by the set hold time- .05 to 59.00S (Seconds), after 59
seconds, the LCD will display “1M00S”, “M” represents minutes and can be adjusted
up to 10M00S (10 minutes and 0 seconds). “F” represents Fade time.
(5) Once your scene is selected and your speed and fade times have been set, press the
“RECORD” button, all of the LED’s will flash one (1) time and your Show step will
advance one (1) time as well. The LCD will display the following:
EDIT SHOW1/TL01
ADD ESC STEP01
• “TL” represents total Show steps and “STEP” represents current Show step. This
becomes important when wanting to edit your Show later (See Editing Moving
Light Shows in section 7.5 on page 18).
(6) Repeat steps 3-5 to continue recording additional steps into your Show. Each time
you record a new scene into your Show, the Show step will advance by one (1). You
can store up to 99 steps maximum per Show.
(7) Once you’ve completed recording your Show, press the “ESC” button two (2) times
to exit record mode.