Electrolux 316520101 Getting Started, Setting clock at power up Timers, Wave-Touch display modes

10Getting Started

Setting clock at power up Timers

You will be prompted to enter the time of day in the event of a power failure or when you first provide electric power to your appliance.

•When your appliance is first powered up, 12:00 will flash in the display.

•Enter the time of day using the numeric key pads and press START to set.

If an invalid time of day is entered, the control will triple beep. Re-enter a valid time of day and press START. If CANCEL is pressed your clock will start with the time set for 12:00.

Select the user pref key to modify the time of day during other situations such as day light savings.

Wave-Touch™ display modes

Sleep mode

Your control will remain in a sleep mode -Fig.1-when not in use, unless there is a hot element. Only the clock will display during this mode. You will need to wake the control to begin any function.

Awake mode

To awake the control -Fig. 2- touch within the display panel. If the control panel is not touched again within 2 minutes, the control will return to the sleep mode. To start cooking you must select either the upper oven, lower oven, or a surface element. User preferences will be available during this mode as well as timers, oven light and the control lock.

Sleep mode

The two timers provided with the oven control serve as extra reminders in the kitchen. When a timer reaches less than 1 minute the display will start to count down in seconds. When the time runs out the active timer will beep, “00:00” will display and the timer key will flash.

The following time settings apply to the timers:

•Min. time: 1 minute

•Max. time: 11 hours 59 minutes

See example below to set the timer for 5 minutes:

Example

Step Press

1. Press TIMER

2. Enter 5 minutes

3. Press TIMER

To cancel after setting the timer, press the TIMER key again.

NOTE

The timer(s) will not affect the cooking process.

Fig.1

Awake mode Fig.2