Electrolux 95387831900, 125H instruction manual Operation

ENGLAND

E1

EMPTYING THE GRASS COLLECTION BAG(starts at page 86)

Empty the grass collection bag in time before it overflows. The red light situated under the steering wheel shows that the bin is full.

Don’t go on filling the grass collection bin when the red light situated under the steering wheel is on.

Switch off the engine.

1.Hold the rod and swivel the bag. Shake the bag twice until it is completely empty.

2.Let the grass collection bag return slowly to its original position.

3.Switch on the engine.

CARE OF THE LAWN AND MOWING

The modern gardening technology has designed and developed labour-saving devices (mower with grass collection bag). For a good, healthy green lawn, it is essential to mow and aerate it regularly.

Fertilising is also essential.

Always make sure the blades are sharp and in perfect conditions to avoid grass fraying and yellowing of the lawn. .

You will achieve a clean cut with regular and straight windrows.

The mowing tracks should always overlap a few centimetres to avoid any uncut strips in between.

Lawn cutting frequency depends on the rate of growth. In the main growing season (May-June) often (twice a week) or at least once a week.The cutting height should be between 4-6 cm. and the growth before the next cut should not be more than 4- 5 cm.

During hot and dry periods, the lawn should be cut 1,5 cm. higher than normal, to avoid ground and root drying out.

If the grass is somewhat higher than normal, you should not make the mistake of cutting it immediately; you can damage the lawn. Do no cut to more than half the necessary height.

F

F1

SAFETY PRECAUTIONS (starts at page 87)

Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been missed.

(starts at page 87)

Never place your hands or feet underneath the deck or into the rear discharge chute while the engine is running.

OPERATION

PUTTING THE RIDE-ON LAWNMOWER INTO OPERATION FOR THE FIRST TIME

Don’t put the ride-on lawnmower into operation before you have completely finished its assembly. Before putting the ride-on lawnmower into operation for the first time, don’t forget to fill it with petrol and oil. Connect the red cables to the positive terminal and the black cables to the negative terminal (the battery is placed in battery holder under the motor safety housing on the right of the seat).

STARTING THE ENGINE

The ride-on lawnmower may be put into operation for the first time only by trained persons only who have read and fully understand the operating instructions.

Use the following on your ride-on lawnmower:

Petrol	lead free (min. octane rating 77)
engine oil	SAE 30 ("SE", "SF" O "SG")

G

Start up the engine only after filling the tanks with sufficient petrol and oil.

Carefully follow the instructions in the enclosed engine manufacturer’s operating and maintenance manual.

REFUELLING (starts at page 87)

Danger of explosion! Fill the tank only only in an open area! Never refuel while the engine is running or is very hot! Do not smoke!

The petrol tank is placed in the engine block below the seat.

1.Lift the seat

2.Unscrew the tank cap (23) and fill up with lead-free petrol.

3.Screw the tank cap back.

TOPPING UP WITH OIL

Use only oil of type SAE 30 (“SE”, “SF” or “SG”). Ensure that no oil is spilt onto the ground.

The oil filler cap is placed in the engine block, below the seat.

1.Lift the seat

2.Unscrew the oil filler cap (24)

3.Fill up the oil until the “MAX.” mark on the dip stick is reached

4.Replace the oil filler cap.

ELECTRIC ENGINE START

The exhaust fumes contain carbon monoxide, an odourless and deadly gas. Never start the engine in closed or badly ventilated rooms.

H

(starts at page 88)

Look for a flat piece of ground with short grass for starting the engine.

Operate the electric start only when sitting on the tractor with the blade clutch (8) in stop position and with brake engaged.

1.Set the clutch blade (8) to STOP position

2.Set the throttle lever (6) to START position

3.Press the brake pedal (9 - Fig.I).

H1

(starts at page 88)

4.Insert the ignition key in the ignition block (5)

5.Turn the key to the right and release it, after starting in “RUN” position. The green light positioned beneath the steering wheel control remains on. Should the engine fail to start within 5 seconds, to avoid damaging the battery, wait a further 10 ten seconds before trying again.

	(starts at page 88)
H2	7. Set the lever (6) between		and	until you judge the revs to be correct for your work
		Do not touch ignition key while running.

SWITCHING OFF THE ENGINE

To switch off the engine position the key to “STOP”. The red light goes off.

Only switch the engine off when the machine is at a complete standstill.

Always remove the ignition key to prevent accidental starting.

16