Electrolux E30DF74GPS 28General Care & Cleaning, Surface Burner, Grate 2 or, Caps 4 or, Heads

28General Care & Cleaning

CLEANING THE BURNER GRATES, BURNER CAPS, BURNER HEADS, SIMMER PLATE AND GRIDDLE

Surface BurnerGrate 1st

Surface 2nd Burner Cap

Surface 3rd Burner Head

Electrode

The Burner Grates, Burner Caps, Burner Heads, simmer plate and griddle should be routinely cleaned. Keeping the burner ports clean will prevent improper ignition and an uneven flame.

Refer to the following instructions:

To Remove and Replace the Surface Burner Grate, Surface Burner Cap and Surface Burner Head - Remove in the following order: (1st) Surface Burner Grate, (2nd) Surface Burner Cap, (3rd) Surface Burner Head; 18000BTU Dual Flame Burners Only (See Figure).

Reverse the procedure above to replace the Surface Burner Cap, Surface Burner Head and Surface Burner Grate. Do not remove any burner parts from the cooktop until the burner parts have completely cooled and are safe to handle. Do not operate the surface burners without the Surface Burner Caps, Surface Burner Heads and Surface Burner Grates properly in place.

To Clean the Burner Caps, Burner Heads, Burner Grates, Simmer Plate and Griddle

-Use a soap-filled scouring pad or a mild abrasive cleaner to clean the surface burner caps and surface burner heads. The Grates, Simmer Plates and Griddle are designed to be Dishwasher safe for cleaning. The ports (or slots) around the burner heads must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes being careful not to damage the electrode. For proper flow of gas and ignition of the burner—DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS

OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS make sure that the surface burner cap, the surface burner head and the surface burner grate are properly in place whenever a surface burner is in use.

Surface Burner	Surface Burner	Surface Burner
Grate (2 or 3)	Caps (4 or 6)	Heads

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

!CAUTION

-Use caution when replacing the burner head so the electrode is not damaged. A damaged electrode may cause a delayed ignition or prevent the burner from igniting

-Any additions, changes or conversions required in order for this appliance to perform satisfactorily must be made by a qualified service technician.