Installation 15
INSTALLING THE 36” RANGE OPTIONAL
BACKGUARD
Your Electrolux IconMR range was shipped with a backguard in place. These instructions cover the installation of one of the optional backguards.
Installing the Range Optional Backguard:
WARNING
Be sure the range is not connected to gas or power before proceeding.
1.Remove existing backguard by removing 4 screws on rear of backguard (2 screws per side).
2.Remove the backguard from its box.
3.To avoid scratches, place small scraps of thin cardboard on the rear of the side panels where the backguard will make contact. With the assistance of at least one other person, carefully lift the backguard and place down on to the range top. Special attention should be given to the lower flange in front of the backguard, which must be fit between the stainless steel side panels.
4.Fasten the screws through the rear flange in the same location in which they were removed from factory supplied backguard.
5.Connect the gas line to the regulator. Reposition and attach the access panel or the back cover if the entire back cover was removed.
6.You are now ready to continue with the range installation.
Figure 3
Backguard
Backguard Installation
(36" range shown)