18Installation
CONNECT RANGE TO GAS SUPPLY
WARNING
•Do not apply excessive pressure when tightening gas connections and fittings.
•Do not use teflon tape or plumber’s putty on gas flex line connections.
•Turn all control valves to the “OFF” position. Turn on gas supply and check all lines and connections with leak detector, such as soap and water solution. Do not use flame to check for leaks. After verifying that there are no gas leaks, turn off the gas supply to the range by turning the gas
For LP installations, the LP gas tank must have its own high pressure regulator. This is in addition to the pressure regulator provided with the range.
The maximum gas supply pressure to the regulator must never exceed 1/2 pound per square••
INSTALLING THE RANGE
WARNING
The 30” and 36” ranges require an
Measure from the floor to the countertop and adjust the leveling legs as required to position the top frame at the desired height, based on the cabinet and countertop installation. Carefully slide the range into position in the cutout.
Make sure the anti-tip bracket is installed as directed on page 14.
1.Slide range forward.
2.Make sure the
3.Safely slide the range slightly and move back against wall, making sure the pin slides under bracket.
Installing the burner components
Remove the burner bases, burner heads, burner caps, and porcelain grates from their shipping packages. Place each burner onto its corresponding burner base, being certain that the burners align with the ignitor correctly. Set each burner cap on top of its corresponding burner head. Place each grate onto the top frame.
WARNING
Never attempt to operate the cooktop section of the range with any of the burner caps or grates removed.