24 www.electrolux.com
A |
A |
CAUTION!
Be careful when you remove the door from the appliance. The door is heavy. There is a risk of injury or damage to the appliance.
Removing the door
1.Open the door as far as it goes.
2.Fully press the clamping levers (A) on the two door hinges.
45° |
3.Close the door until it is at an angle of approximately 45°.
4.Hold the door with one hand on each side and pull it away from the appli- ance at an upwards angle.
Put the door with the outer side down on a soft and level surface to prevent scratches.
Installing the door
| To install the door do the above steps in | ||
| the opposite sequence. | ||
|
|
| |
LAMP | 2. | Use a Torx 20 screwdriver to remove | |
WARNING! |
| the cover. | |
3. Remove and clean the metal frame | |||
There is a risk of electrical shock. | |||
| and the seal. | ||
The lamp and the lamp glass cover |
| ||
4. | Replace the lamp with a suitable 300 | ||
can be hot. | |||
| °C | ||
|
| ||
Before you change the lamp: | 5. | Install the metal frame and the seal. | |
• Deactivate the appliance. |
| Tighten the screws. | |
6. | Install the left shelf support. | ||
• Remove the fuses from the fuse box or | |||
|
| ||
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the in- terior of the appliance. It prevents damage to the lamp glass cover and the cavity.
Always use the same lamp type.
Replacing the top lamp
1.Turn the lamp glass cover counter- clockwise to remove it.
2.Remove the metal ring and clean the glass cover.
3.Replace the lamp with a suitable 300 °C
4.Attach the metal ring to the glass cov- er.
5.Install the glass cover.
Replacing the side lamp
1.Remove the left shelf support.
