Electrolux EBGL70 user manual Installing the Oven Under a Work Surface, Electrical Connection, Min

28 www.electrolux.com

A

2.Use a minimum of 2 screws to attach the appliance on the 2 sides (Detail A).

INSTALLING THE OVEN UNDER A WORK SURFACE

Before the installation, connect the oven to the electrical supply. Refer to "Electrical connection".

			B
	180		ca.50
A	A		N 600
			A 595
			442
	115
	N min. 550
	A 567
	20
	N 560-568
	A 592
	A	B	min. 20
			15
		20	A

A = appliance

N = recess

WARNING!

Installation into flammable material must agree with NIN SEV 1000 (Association of Cantonal Fire Insur- ers) fire protection guidelines and regulations.

CAUTION!

Make sure the cable is free when you move the appliance.

1.Push the cooker into the recess so that it is flush with the surrounding units.

2.Use at least 2 screws to fix the appli- ance on both sides (Detail A).

WARNING!

When installing next to a wood-fu- elled boiler, a heatproof and heat- insulating plate must be mounted at the height of the appliance and at least 30 cm deep.

ELECTRICAL CONNECTION

Use a power cable of H05VV-F or higher. Connect the appliance to a socket supply line. If there is no socket supply line, the electrical installation must have an isolation device which lets you disconnect the appli- ance from the power supply. The isolation

device must have a contact opening width of minimum 3 mm (in reference to NIN SEV 1000). The customer must have a socket for the electrical connection that is accessi- ble and outside the coordination room. The length of the connection cable must be ap- proximately 120 cm with lines connected directly to the power supply.