Electrolux EI30EC45KB, EI30EF35JS manual Setting fresh clean cont’d, Setting delayed fresh clean

46Fresh clean

Setting fresh clean (cont’d)

To cancel fresh-clean:

1.Press the cancelkey.

2.If the self-clean cycle has heated the oven to a high temperature, "Hot" (Figure 1) will show in the display. Allow enough time for the oven to cool and for the "door OPn" message to display (Figure 2). When this message turns OFF the oven door may be opened.

Fig. 1 Fig. 2

Starting fresh clean after cancelling:

If a self-clean cycle was cancelled using the cancel key before the oven was finished cleaning, you may wish to set for another self-clean cycle.

If self-clean was cancelled shortly after being started, and the oven interior did not reach high self-clean temperatures, the next clean cycle may be set as soon as the oven door unlocks from the cancelled clean cycle.

If the oven became hot enough from the cancelled self-clean cycle, you may be required to wait up to 4 hours before the control will allow another self- clean cycle to start.

Restarting a fresh clean cycle after a power outage:

If the self-clean cycle was interrupted by a power failure, your oven may not be thoroughly cleaned. Another self-clean cycle may be needed. Once power is restored, the oven has cooled and the oven door has unlocked, set to clean for another cycle.

Setting repeated fresh clean cycles

If attempting to set repeating self-clean cycles, the control may display the messages "CLEAn"” then "dELAy" followed by the length of time before the next self-clean may be set.

For example, if the message displayed reads

"4:00", and the time is 12:00 o’clock, the control will not allow self-clean to be set again until after 4:00 o’clock.

Setting delayed fresh clean

You may wish to set your appliance to perform a self-clean cycle later (up to 12 hours later). The end time key will determine when the cleaning will stop.

You will need to set the end time far enough to allow for the type of clean cycle you choose, whether for 2, 3, or 4 hours. Remember to add

30 to 40 additional minutes of cooling time before using the oven for cooking.

Setting for a heavy (4 hour) fresh clean cycle to end at 8:00 o’clock:

Example

Step Press

1.Be sure the clock is set with the correct time of day. Remove all oven racks. Remove all items from the cooktop. Be sure the oven door is completely closed.

2. Press end time.

3.Enter 8 0 0 using the numeric keypad.

4. Press START.

5. Press fresh clean.

6. Press fresh clean again.

7. Press START.

Press CANCEL at any time to stop fresh clean.

CAUTION

To avoid possible burns use caution when opening the oven door after the self-clean cycle is finished. The oven may still be VERY HOT. Stand to the side of the oven when opening the door to allow hot air or steam to escape.