Installation Instructions
D.ALIGNING THE WALL PLATE
Hole A | Centerline |
| notches |
Horizontal Line | Area E |
Draw a Vertical Line on Wall from Center of Top Cabinet
C
L
Hole C | Hole B Horizontal Line |
CAUTION: Wear gloves to avoid cutting fingers on sharp edges.
1. Draw a Vertical line on the wall at the center of the 30" wide space.
2. Draw a Horizontal line on the wall at the bottom of “Rear Wall Template”.
3. Drill 5/8" holes for toggle bolts on 3 locations (Hole A, Hole B, Hole C) but if the location of hole is same as that of stud, drill a 3/16" hole for wood screw. In other words, toggle bolt can not be used to the location of stud.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
Draw a Horizontal line on wall from bottom of “Rear Wall Template”.
NOTE: Holes A, B and C are inside area E. If none of A, B and C is in a stud, find a stud somewhere in area E and draw a forth circle to line up with the stud. It is important to use at least one wood screw mounted firmly in a stud to support the weight of the microwave. Set the mounting plate aside.
10
