Installation Instructions
1.PLACEMENT OF THE MOUNTING PLATE
A.REMOVING THE MICROWAVE OVEN FROM THE CARTON/ REMOVING THE MOUNTING PLATE
1. Remove the installation instructions, Exhaust adaptor, filters, glass tray and the small hardware bag. Do not remove the Styrofoam protecting the front of the oven.
2. Fold back all 4 carton flaps fully against carton sides. Then carefully roll the oven and carton over onto the top side. The oven should be resting in the Styrofoam.
Carton
Styrofoam
3. Pull the carton up and off the oven.
4. Remove and properly discard plastic bags.
ScrewsScrews
Mounting Plate
5. Remove the 2 screws from the mounting plate. This plate will be used as the rear wall template and for mounting.
NOTE: You will have to reuse two screws in original loction of outcase after removing mounting plate.
B.FINDING THE WALL STUDS
Wall Studs
Center
1. Find the studs, using one of the following methods:
A. Stud
OR
B. Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate a stud location.
2. After locating the stud(s), find the center by probing the wall with a small nail to find the edges of the stud. Then place a mark halfway between the edges. The center of any adjacent studs should be 16" or 24" from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT LEAST ONE WALL STUD.
8
