Installation Instructions
6. Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End A
End B
CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven.
7. Secure the blower unit to the microwave with the screw.
Back of | From the Mounting |
Microwave | Plate screw |
8. Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven.
Adaptor
Back of
Microwave
| Guide |
Guide | From Blower motor screw |
| (after attached the exhaust adaptor) |
Push in securely until it is in the lower locking tabs. Take care to assure that the damper hinge is installed so that it is at the top and that the damper swings freely.
C5. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during installation.
NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.
NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws.
NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps
1. Lift microwave, tilt it forward, and hook slots at back bottom edge
onto four lower tabs of mounting plate.
2. Rotate front of oven up against cabinet bottom
3. Insert a
tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet.
20
