COMPONENTS FOR THE
INSTALLATION
The coffee machine is equipped with the following components for the installation (C):
1.2
2.4
3.2 telescopic runners
4.1 mains terminal block
5.1 cabinet lock tongue
6.1 cabinet locking bar
7.2 L brackets
8.2 rectangular washers
9.1 mains power cable
10.4 double stickers for fixing the plates
11.8 screws M4X16
12.12
13.4 washers
ELECTRICAL CONNECTION
Fix the mains terminal block (C-
4)to the top back left corner of the cabinet (O/1).
Connect the mains cable to the terminal block ensuring correct polarity (C/4), and connect the coiled mains input cable between the appliance and the terminal block.
USE OF THE SIDE PLATES
The width of the cabinet in which the coffee machine should be inserted is determined by the thickness of the cabinet’s sides. To compensate the different possible measurement, the appliance is equipped with 6 plates, 4 are 2mm in thickness and 2 are 1mm. thick. They should be used to
20
compensate the internal width of the seat. For obtaining a width of 562/560mm see picture P/1 and P/2.
INSTALLATION WITHOUT
SUPPORT
Put the suitable plates (P/1,P/2) on the both sides of the housing, fixing them with the double- sticker strips (Q/1). Pay attention to the position of the bevel which indicates the right position of the plates.
Release the telescopic runners and extract the front section (Q/2)
Fix the telescopic runners’ bearings with the screws as shown in picture Q/3
Fix the 2 L brackets as shown in picture Q/4
Install the cabinet locking bar using the rectangular washers and the specific M4 screws as shown in picture Q/5
Install the telescopic runners on the both sides of the machine as shown in picture Q/6
Insert the machine: the telescopic runners should be coupled with the runners‘ bearings which are already fastened on the sides. (Q/7)
Check the safety lock clicks when the runners are pushed in.
Adjust the cabinet locking bar if necessary, for the correct locking position of the machine, and tighten the screws as shown in picture Q/8
Push the cabinet block button so that the machine will be well fastened (F/2).
