Electrolux WFGUOAOOOO manual Access to Interior, Sidewall D Assembling on Castors, Steel Plinth

INSTALLATION INSTRUCTIONS

1.4 SIDEWALL (D) 1.6 ASSEMBLING ON CASTORS

(5)

(4)

a

b

Fig.2 Assemblage of sidewall

The assembly kit contains two of each of the following: hexagonal screws M8x25 (1 / Fig.1), bolts with retaining rings

(2 / Fig.1), mounting links (3 / Fig.1), hexagonal screws M8x16 with serrated washers and hexagonal nuts M8, hexagonal screws M5 with serrated washers (4 / Fig.2)

and a fastening angle (5 / Fig.2).

DInsert the bolts with the retaining rings (2 / Fig.1a) from out- side into the guide in the sidewall.

DKeeping the screw (1 / Fig.1a) loose, turn it until it is approximately 5 mm deep in the pre-assembled caged nuts in the sidewall.

DAttach the fastening angle (5 / Fig.2b) to the bottom of the frame using the screws, serrated washers and nuts.

D(4 / Fig.2).

DPosition the sidewall and screw it on from below using two hexagonal screws and the serrated washers.

DFit the mounting link (3 / Fig.1b) into the inside of the appli- ance's connecting plate.

DAlign the sidewall and firmly tighten all screws.

1.5STEEL PLINTH

a

b c

Fig.4 Assemblage on castors

The assembly kit for mounting on castors contains two cross bars (2/Fig.4a) each with a fixed rear wheel (1/Fig.4a) and a turnable front wheel (3/Fig.4a).

Mounting the castors:

DPut the appliance on supports.

DRemove the feet; each is tightened with four screws (Fig.4b).

DBring the two cross bars into the correct position below the appliance and fasten it with 8 screws arrows (Fig.4a).

DRemove the supports.

DFasten the appliance to the building. Use the hole to attach a chain descending from the wall (arrow/Fig.4c). Making sure the chain is shorter than the gas and electric connec- tions.

Note:

(3)

	(2) b
b	(1)

a

(3)(1)

(2)

b

Appliances on wheels must be secured by fasten it to the building.

2.ACCESS TO INTERIOR

Note:

Only authorized technicians may access the interior.

E

Fig. 3 Plinth assembly

To assemble the plinth you will need:

•Right and left side plinth (1 / Fig.3).

•Plinth for the front and, for free-standing appliances, for the rear also (2 / Fig.3).

DPush the side plinth (1 / Fig.3) onto the legs from front to rear using the fastener. The larger gap (b / Fig.3) on the fastener must be at the bottom.

DAffix the fasteners (3 / Fig.3) to the plinth (2 / Fig.3).

DThe larger gap (b / Fig.3) on the fastener must be at the bottom.

DAttach the plinth with the fasteners (3 / Fig.3) onto the feet.

	C
	B
D	D
11 3	3 11

Fig. 5 General view

Seite 6 62.9679.01_UL