ENGLISH
35
• failure to disconnect the power supply with the main
switch in off position “O” at the end of the day;
• lack of machine maintenance, cleaning and periodi-
cal checks;
• structural changes or modifications to the operating
logic;
• tampering with the guards or safety devices;
• failure to use personal protection equipment by oper-
ators, specialized technicians and maintenance per-
sonnel;
• failure to use suitable accessories (e.g. use of equip-
ment, ladders, etc., unsuitable for carrying out main-
tenance on equipment positioned inside the
machine);
• keeping combustible or flammable materials, or in
any case materials not compatible with or pertinent to
the work, near the machine;
• incorrect machine installation (see chapter E “Instal-
lation and assembly”);
• placing in the machine any objects or things not com-
patible with washing or that can obstruct/damage the
machine or persons or pollute the environment;
• non-compliance with the requirements for correct
machine use;
• other actions that can cause risks not eliminable by
the Manufacturer.
H5 Residual risks
The machine has several risks that were not completely
eliminated from a design standpoint or with the installa-
tion of adequate protection devices.
Nevertheless, through this manual the Manufacturer has
taken steps to inform operators of such risks, carefully
indicating the personal protection equipment to be used
by them.
Sufficient spaces are provided for during the machine
installation phases in order to limit these risks.
To preserve these conditions, the corridors and areas
around the machine must always be:
• kept free of obstacles (e.g. ladders, tools, containers,
boxes, etc.);
• clean and dry;
• well lit.
For the Customer’s complete information, the residual
risks remaining on the machine are given below; such
actions are to be considered incorrect and therefore
strictly forbidden.
Table 3 Residual risks
RESIDUAL RISK DESCRIPTION OF HAZARDOUS SITUATION
Slipping or falling The operator can slip due to water or dirt on the floor.
Catching, dragging or crushing Catching or dragging of the operator or other persons in the drive, during the
machine work phase, due to improper actions, such as:
- placing an arm inside the machine to remove a stuck rack without stopping
the machine by operating an emergency switch;
- accessing the rack handling system without stopping the machine by oper-
ating an emergency switch.
Use of improper clothing with loose parts (e.g. necklaces, scarves, shawls,
ties, etc.) or long hair not gathered, which could get caught up in moving parts.
Burns The operator deliberately or unintentionally touches some components inside
the machine or dishes at the outfeed without using gloves or without allowing
them to cool.
Shearing of upper limbs The operator violently closes the front panels.
Electrocution Contact with live parts during maintenance operations carried out with the
electrical panel powered. The operator intervenes (with a power tool or without
disconnecting the power to the machine) lying down on the wet floor.
Falling from above The operator intervenes on the machine using unsuitable systems to access
the upper part (e.g. rung ladders, or climbs on it).
Tipping of loads During maintenance on the machine or the packing containing the machine
with the use of unsuitable accessories or lifting systems or with load unbal-
anced.
Chemical Contact with chemical substances (e.g. detergent, rinse aid, scale remover,
etc.) without taking adequate safety precautions. Therefore always refer to the
safety cards and labels on the products used.