When Preset Touringis setup for a PTZ camera, the time that the camera will remain at each preset is defined by entering the
DwellTime value on Hardware Setup page.
Tosetup the dwell time for preset touring, follow these steps:
1. ClickSetup on the main screen.
2. Clickthe Hardware Setup tab.
3. Locatethe Preset Touring section at the bottom of the Hardware Setup tab. See picture below:
4. Entera desired Dwell Time.
5. ClickSave to save settings.
' '
))%
Sensorsetup is only applicable if sensors are available and are being used.
Figure 7. Sensor Setup

'  '

Toset up sensors, follow these steps:
1. ClickEnable on the sensor you wish to activate.
2. ClickNC/NO to select the type of sensor connection (NC - Normally Closed, NO - Normally Open).
3. SpecifyPost Recording amount if applicable.
'' 11