Installation
3.9Set Up Liebert MultiLink software
To start using Liebert MultiLink (software and user manual available at multilink.liebert.com):
•Install the software.
See the Liebert MultiLink
•Connect one end of the USB cable (supplied) to the USB port on the rear of the UPS. Connect the other end to a USB port on the computer.
See the Liebert MultiLink user manual for operating instructions.
NOTE
Emerson recommends connecting the USB cable directly to the computer WITHOUT using a USB hub.
3.10EPO Switch
The Liebert PSI XR is equipped with an Emergency Power Off (EPO) switch. The user must supply a means of interfacing with the EPO circuit to allow disconnecting the UPS input feeder breaker to interrupt all sources of power to the UPS and connected equipment to comply with national and local wiring codes and regulations.
Figure 13 EPO connection for normally open operation
2 = Ground
1 = EPO+
Short Pin 1 and Pin 2 to enable the EPO function
12
