Emerson 5081-P-FF/FI Start-Upconfiguration And Calibration - Orp, Menu Tree for ORP, 2511 mV

MODEL 5081-P-FF/FI START-UP - ORP

START-UP CONFIGURATION AND CALIBRATION — ORP

To perform a one point standardization, follow these steps.

1.Place the ORP sensor in the ORP buffer solution.

2.On the Remote press CAL, ENTER, ENTER

3.Use the arrow buttons to adjust the value. Press ENTER

4.Press RESET

		2511 mV
CALIBRATE		PROGRAM			DIAGNOSE
Std	tEMP ADj
				OFFSt 120	rIMP 10	5081-P-FF SoFt 00.02	HArd 01	FAULtS
Std 1000	tEMP 25.0
								nonE
	dIAGnOStIC	dISPLAY	LinE FrEq	PAMP=trAnS
	rOFFSt 060	tYPE ORP	LinE 60
	dIAG OFF	tEMP C
	IMPtC OFF	OUtPUt CUr				MENU
	rEF LO	COdE 000
	rFH 140					Sub-menu
	rWH 040
	rWL 000					PROMPT
	rFL 000
						Diag Message
		FIGURE 15. Menu Tree for ORP
								27