Commissioning, Verify Operation | Emerson 708 instruction

Reference Manual

00809-0100-4708, Rev AD September 2012

Rosemount 708

Section 4 Commissioning

Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4-1

Verify Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4-1

SAFETY MESSAGES

Instructions and procedures in this section may require special precautions to ensure the safety of the personnel performing the operations. Information that potentially raises safety issues is indicated by a warning symbol (). Please refer to the following safety messages before performing an operation preceded by this symbol.

Warnings

Failure to follow these installation guidelines could result in death or serious injury.

•Make sure only qualified personnel perform the installation.

Explosions could result in death or serious injury:

Installation of this transmitter in an explosive environment must be in accordance with the appropriate local, national, and international standards, codes, and practices. Please review the Product Certifications section for any restrictions associated with a safe installation.

•Before connecting a Field Communicator in an explosive atmosphere, ensure the instruments are installed in accordance with intrinsically safe

VERIFY OPERATION

NOTE

The Rosemount 708 and all other wireless devices should be installed only after the Gateway has been installed and is functioning properly.

Wireless devices should be powered up in order of proximity from the Gateway, beginning with the device closest to the Gateway. This will result in a simpler and faster network installation.

There are three ways to verify operation: using the Field Communicator, using the Gateway’s integrated web interface, or by using AMS® Suite Wireless Configurator or AMS Device Manager.

If the Rosemount 708 was configured with the Network ID and Join Key, and sufficient time has passed, the transmitter will be connected to the network. If Network ID and Join Key were not configured, please reference Troubleshooting on page 4-3.