5.Obtain the die cast glass holders and light kit glass from the protective bags.
6.Position the light kit glass carefully on a convenient surface with the open side face down.
7.Remove the protective cover from the adhesive backed material on the glass holders (Figure 18).
PROTECTIVE COVER ON
ADHESIVE BACKED MATERIAL
LIGHT KIT
GLASS
TURN KNURLED KNOB SCREW SEVERAL TURNS INTO THE GLASS HOLDER
Figure 18 | DIE CAST |
GLASS HOLDER |
8.Firmly press the die cast glass holders into position on the light kit glass (Figure 19).
LIGHT KIT
GLASS
| DIE CAST |
Figure 19 | GLASS HOLDER |
|
9.Repeat these procedures for the second die cast holder.
10.Carefully turn the light kit glass assembly over. Thread two knurled knob screws (supplied) several turns onto the die cast glass holders (Figure 20). Leave approximately 3/16” of the stud threads revealed.
Figure 20
11.Raise the light kit glass assembly and insert the two knurled knobs through the two keyholes in the light kit adapter. Turn the light kit glass assembly counterclockwise to engage the knurled knob screws in the slots (Figure 21). Carefully reach between the fan blade flanges and the light kit glass and securely tighten the two knurled knob screws.
LIGHT KIT ADAPTER
KNURLED KNOB
SCREW
ROTATE LIGHT KIT GLASS
COUNTERCLOCKWISE
LIGHT KIT GLASS
VIEWED FROM TOP
Figure 21
12.Your ceiling fan is now installed and wired and ready for use.
10
