Emerson CF2455PW00, CF2455BS00 Setting Operating Frequency of Wall Control Receiver Figure

Setting Operating

Frequency of Wall Control

and Receiver (Figure 22)

Your wall control and receiver have code switches which must be set in one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and

4)on the switches are factory-set in the ON (up) position. Change the switch settings as follows:

1.Slide the four switch levers in the wall control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

2.In the receiver, slide the four switch levers to the same positions as set in the wall control. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate.

SW105 RECEIVER

CODE

SWITCH

WALL CONTROL

LEVERS

4	3	2	1
			ON

ON

1 2 3 4

	RECEIVER SWITCH
	LEVERS	HIHI
		U/LU/L
		MEDMED
		D/L
		D/L
		LOWLOW
		REVREV
		FAN OFF
	SW116 WALL
	CONTROL	CODE
Figure 22		SWITCH

Battery Installation

of Wall Control

!WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box.

The SW116 wall control transmits the command signals via radio waves to the SW105 receiver installed in the ceiling fan ceiling cover. The SW105 receiver is required for the SW116 wall control to function. Power for the SW116 wall control comes from the 12V battery, located in the wall control.

Replacement 12V batteries recommended are Duracell MN21, Eveready A23, and GP23A.

1.Install the 12V battery (supplied) into the wall control (Figure 23).

2.The SW116 wall control is supplied with a white or almond color cover. Choose the style that best suits your needs and snap the cover onto the wall control (Figure 23).

HIHI

U/LU/L

MEDMED

D/L

D/L

LOWLOW

REVREV

FAN OFF

EMERSON
WALL		SW116
	12V BATTERY	WALL
CONTROL
		CONTROL
Figure 23 COVER

3.Install the wall control onto the outlet box using the supplied screws (Figure 24).

4.Install decorator faceplate (included) using the two screws provided. Leave wall control in “OFF” mode until fan installation is completed (Figure 24).

DECORATIVE	OUTLET BOX
FACEPLATE
	HI
	U/L
	MED
	D/L
	LOW
	REV
	FAN OFF
	EMERSON

SW116 WALL CONTROL

FACEPLATE	WALL CONTROL
	SCREW (2)
SCREW (2)

Figure 24

11