Emerson CF2455BS00, CF2455ORB00, CF2455PW00 owner manual Final Assembly

	SW105 RECEIVER
	BLACK/WHITE RECEIVER WIRE
	BLACK
WHITE RECEIVER WIRE	SUPPLY	WHITE
	WIRE	SUPPLY
BLACK RECEIVER WIRE		WIRE

BLUE RECEIVER WIRE

WHITE FAN WIRE	YELLOW RECEIVER WIRE
BLACK FAN WIRE	BLUE FAN WIRE
	YELLOW FAN WIRE

DOWNROD

Figure 15

!WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

4.After connections have been made, separate the white and green wires from the black, blue and yellow wires.

5.Carefully turn the wires upward and insert them up through the open side of the hanger bracket and into the outlet box. Push the green and white wires into one side of the outlet box; push the black, blue and yellow wires into the other side of the outlet box.

HANGER

BRACKET

1-1/4"

THREADED

STUDS (2)

Figure 16

OUTLET BOX

RECEIVER

CEILING

COVER

Final Assembly

1.Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 16).

2.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 17).

3.Secure the ceiling cover in place by installing two lockwashers and two knurled knobs (supplied) (Figure 17). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod.

4.Screw in three 40-watt (maximum) candelabra base lamps in the uplight assembly sockets and three 60-watt (maximum) candelabra base lamps in the light kit plate sockets for the lower light.

9

CEILING COVER

1-1/4"

THREADED STUD

LOCKWASHER

KNURLED KNOB

Figure 17

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.