12.Position the center styrofoam section on the upper section, and then position the fan motor and housing on the center section so that the bottom of the motor is facing you (Figure 5). The styrofoam sections will hold the assembly while you perform the following steps.

LIGHT KIT PLATE ASSEMBLY

BLUE WIRE

FAN MOTOR AND HOUSING ASSEMBLY

CENTER

STYROFOAM

SECTION WHITE

WIRES

JUMPER ASSEMBLY

UPPER STYROFOAM

SECTION

Figure 5

13.Using the 3/16” setscrew wrench (supplied), loosen the setscrew in the collar of the light kit adapter assembly (Figure 6).

14.Pass the connectors and wires from the motor shaft through the light kit adapter collar (Figure 7) in the following sequence:

a.First, pass the four-pin connector through the collar;

b.Next, pass the single-pin connector through the collar;

c.Then pass the white and blue wires through the collar.

15.Screw the light kit adapter tightly onto the motor shaft (Figure 6), then tighten the setscrew in the collar.

16.Securely connect the jumper assembly (supplied) connectors to the four-pin connector and the one- pin connector from the motor shaft (Figure 7).

BLACK WIRE

Figure 7

LIGHT KIT

ADAPTER

18.Secure the light kit plate assembly to the light kit adapter by threading three 8-32 x 3/8” phillips head screws (supplied) into the threaded holes in the adapter assembly. (Figure 8).

NOTE: Do not pinch wires between the light kit plate assembly and the adapter assembly.

8-32 x 3/8" PHILLIPS HEAD SCREW (3)

LIGHT KIT ADAPTER

LIGHT KIT

PLATE ASSEMBLY

LIGHT KIT

FOUR-PIN

SINGLE-PIN

ADAPTER

CONNECTOR

CONNECTOR

 

 

SETSCREW

 

 

COLLAR

Figure 8

19.Lift the fan assembly from the styrofoam and remove the center styrofoam section. Turn the fan assembly over and carefully position it on the

upper styrofoam section so that the hanger ball/downrod assembly is at the top (Figure 9).

Figure 6

17.Securely connect the black wire from the light kit plate assembly to the blue wire from the motor shaft using a wire connector (supplied) (Figure 7). Connect the white wire from the plate assembly to the white wire from the motor shaft using a wire connector (supplied).

Figure 9

FAN MOTOR AND HOUSING ASSEMBLY

UPPER

STYROFOAM

SECTION

6

Page 6
Image 6
Emerson CF2455BS00, CF2455ORB00, CF2455PW00 owner manual Blue Wire