Emerson CF2455BS00, CF2455ORB00 Unpacking Instructions, Tools Needed for Assembly, Materials

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One six-inch blade screwdriver	One stepladder
One Phillips head screwdriver	One wire stripper

Seven wire connectors (supplied)

Three 40-watt (max.) candelabra base bulbs (uplight) Three 60-watt (max.) candelabra base bulbs (lower light)

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the wire size, to right:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

7.Seven wire connectors

8.Three 8-32 x 3/8" phillips head screws

9.One hairpin clip

10.One clevis pin

11.Two knurled knob screws

12.Twenty-one 10-32 x 3/8" pan head screws

13.One jumper assembly

NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

FAN BLADES

1. Open styrofoam unit containing fan. Remove upper

and center sections of styrofoam unit. Remove parts

and check to see that you have received the following:

a. One fan motor and housing assembly

b. One motor coupling cover

c. One ceiling cover

d. Five fan blades

CEILING

COVER

MOTOR
COUPLING	HANGER BALL/
COVER
	DOWNROD
	ASSEMBLY
BLADE HOLDER
CAPS (LEFT)

UPLIGHT

LEAD ASSEMBLY

HANGER

BRACKET

e. Five blade holder caps (left)
f. Five blade holder caps (right)
g. One hanger ball/downrod assembly
h. One hanger bracket
i. One light kit adapter
j. One light kit plate assembly
k. One light kit glass
l. Two die cast light kit glass holders
m.One uplight lead assembly
n. One SW116 Fan/Light Wall Control
(transmitter)
o. One SW105 Receiver
p. One loose parts bag containing:
1.	One setscrew
2.	One 5/32" hex wrench
3.	One 3/16” hex wrench
4.	Four 8-32 x 1-1/4” threaded studs
5.	Four knurled knobs
6.	Four lockwashers

BLADE HOLDER	LOOSE	SW105
CAPS (RIGHT)
	PARTS	RECEIVER
	BAG
DIE CAST		SW116 FAN/LIGHT
GLASS HOLDERS	EMERSON	WALL CONTROL
LIGHT KIT
GLASS
		LIGHT KIT
		PLATE
		ASSEMBLY
FAN MOTOR
AND HOUSING
ASSEMBLY
		LIGHT KIT
		ADAPTER

3