5.Using wiring connectors (supplied), connect the white, red, blue, brown, and yellow wires from the downrod to the white, red, blue, brown and yellow wires of the ceiling fan (Figure 4). Wires must be connected
SW375 RECEIVER
WHITE WIRE
LEADS TO BE
POSITIONED IN
SLOT IN MOTOR
COUPLING
SETSCREW
DOWNROD
HAIRPIN
CLIP
MOTOR COUPLING
YELLOW WIRE TO YELLOW WIRE
BLUE WIRE TO
BLUE WIRE
BLACK WIRE
WHITE WIRE
RECEIVER
CONNECTOR
WIRING HARNESS
CONNECTOR
BLACK WIRE | BLACK |
| WIRE |
DOWNROD |
|
LISTED GENERAL USE ON/OFF WALL SWITCH (MUST BE
USED WITH SR330
REMOTE CONTROL)
WHITE
WIRE
CLEVIS PIN
DOWNROD
BLACK WIRE (NOT USED)
FAN HOUSING
|
|
| TO |
| 120V SUPPLY | ||
RED WIRE | BLACK | WHITE | |
TO RED WIRE |
|
|
|
BROWN WIRE |
|
|
|
TO BROWN WIRE |
|
| SW350 |
BLUE WIRE |
|
| WALL |
|
| CONTROL | |
TO BLUE WIRE |
|
| |
|
| ||
|
|
| |
WHITE WIRE |
|
|
|
TO WHITE WIRE | BLACK |
| |
YELLOW WIRE |
| ||
|
|
| |
TO YELLOW WIRE
TO
120V SUPPLY
HAIRPIN CLIP
CLEVIS PIN
CLEVIS PIN
MOTOR COUPLING
Figure 5
LIGHT FIXTURE
FAN BLADES REMOVED
FOR CLARITY
Figure 4
6.Fold all wires from the downrod into the slot in the motor coupling, slide the downrod down the wires and seat the downrod in the motor coupling. All wires and wire connectors should be placed through the motor coupling slot beneath the down- rod (See Figure 5).
7.Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip. The clevis pin must go through the holes in the motor coupling and the holes in the downrod (Figure 5). Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose.
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
8.Install the setscrew (supplied in the loose parts bag) in the motor coupling and tighten using the 5/32” setscrew wrench (supplied) (Figure 5).
NOTE: Make sure the unused black motor lead is capped with a wire connector. Make sure all wire connectors are completely inside motor coupling cover and not pinched between the motor coupling cover and motor.
9.Screw two 1” threaded studs (supplied) into the motor (Figure 6). Leave approximately 7/8” of the stud extending above the motor. Slide the motor cover over the downrod and rotate the cover until the threaded studs protrude; install two knurled knobs (supplied) to secure the cover.
KNURLED KNOB
MOTOR
COUPLING
COVER
WIRE
CONNECTORS
1" THREADED STUD
MOTOR | 7/8" |
|
Figure 6
10.Position the ceiling cover over the downrod. Be sure the cover is oriented correctly, with the large opening at the top (Figure 7).
5
